

CALCULATING THE HOSE LENGHT
Service Life of hose can be incrased by proper measure and installation.
To calculate the length of flexible hose assemblies:
L: Total length of assembled hydraulic hose.
B: allowance for a minimum straight section of hydraulic hose at each end of the assembly, measured from the outer end of each coupling.
These 2 straight sections are needed to prevent excessive stress concentrations directly back of the coupling
R: bending radius
T: additional length
The minimum length B, depending on the hose diameter, should be:
| DN | 6 | 8 | 10 | 12 | 16 | 20 | 25 | 32 | 40 |
| B (mm) | 90 | 100 | 110 | 120 | 130 | 140 | 160 | 180 | 200 |
LONGITUDINAL TOLERANCE
| Lunghezza (mm) / Length (mm) | Tolleranze fino a Ø 25 / Tolerances up to Ø 25 | Tolleranze da Ø 32 a Ø 50 / Tolerances from Ø 32 to Ø 50 |
| Fino a / Up to 630 | +7 mm / -3 mm | +12 mm / -4 mm |
| 630-1250 | +12 mm / -4 mm | +20 mm / -6 mm |
| 1250-2500 | +20 mm / -6 mm | +25 mm / -6 mm |
| 2500-8000 | +1.5 % / -0.5 % | |
| Oltre / Over 8000 | +3 % / -1 % |
PROTECTING YOUR HOSE
For an efficient running of the system, hoses have to be protected from surrounding factors that can cause potential damages to the hoses.
The following simple technics can help you in better protect your hoses:
BUNDLING
Only similar construction hoses can be bundled together:
Never bundle high and low pressure hoses together!
Hoses in the same bundle should be in the same plan only.










